Steroids Lab Pharmaceutical Company Ltd.
Nandrolone Phenylpropionate 100mg ml

Nandrolone Phenylpropionate 100mg ml

Nandrolone Phenylpropionate 100mg ml
Similar products
Product Detail
Recipe
Heat Sterilization
Syringe Filtration
Order Process
Our Advantage

Nandrolone Phenylpropionate 100mg ml Product Detail

The Effects of Nandrolone Phenylpropionate (NPP):

Now that we understand the difference between the two nandrolones lets take a look at the compound as a whole. First off, nandrolone is used to treat anemia so logic says it will be very good at raising RBC count which helps delivery of oxygen to muscles.. Its not a tremendous amount but it does the job. Also there is aromatization, so an AI is recommended of course. Nandrolone will aromatize about half as much as testosterone so you can see how deca got so popular with the old school crowd. Since they didn’t have AI’s back then they would use deca over testosterone or dbol (dianabol) to lessen their water weight. Many older lifters at your gym still juice today and have no clue what an AI even means, just ask them, and ask them their favorite steroid and they will likely say deca. Well that’s the reason!

Today in the medical community this compound is used to help HIV/AIDS patients to prevent muscle wasting, however it would be more practical to use the longer ester in this case. Also based on that we can assume that nandrolone is excellent as a immune system support compound and in my personal experience I can confirm this as being true. Another medical advantage is the ability to improve collagen synthesis, so that is why some guys use it to help with joint pain. I am not a proponent of doing this as it can end up backfiring long term.

Nandrolone isn’t very androgenic and is slightly more anabolic than testosterone. Unlike what many believe, nandrolone is a mild steroid with low side effects. I believe people make the mistake of stacking with too much testosterone which leads to very high aromatization and water weight gain which brings on sides and possible gynecomastia.

Nandrolone Phenylpropionate NPP Stacking:

Nandrolone Phenylpropionate makes a great stack with other short esters in an under 10 week cycle. A good cycle for bulking would be the classic NPP and test prop cycle. NPP at 300mg per week for 10 weeks, test prop at 300mg per week for 10 weeks. Notice I did not include an oral to kickstart the cycle as its not necessary with these short acting esters. Don’t forget also to use an aromatase inhibitor (AI).

Nandrolone Phenylpropionate (NPP) Has The Shorter Ester.

Nandrolone Phenylpropionate (NPP) is the lesser known and less popular phenylpropionate ester version of nandrolone. First off its important to understand the difference between what we know as ‘deca’ and what we know as “NPP”. To put it in simple terms the difference is simply the ester. NPP has the shorter ester while deca durabolin version of nandrolone has the longer ‘deca’ ester. Many lifters have no clue they can use the compound they love so much in a shorter ester. The only disadvantage would be the amount of injections, the shorter ester would have to be injected every other day or every 3 days at the most, while the long ‘deca’ ester can be injected once or twice a week. However the advantages are there which I will discuss as we go along.

The main reason Nandrolone Phenylpropionate never became as popular as the deca ester is because of the availability and the small amount of amount per ml in the pharm grade version. Deca Durabolin meanwhile came in 200  mg per ml so really guys found it much easier to inject 200mg twice a week using just 1ml per injection. Now with the growth of underground labs this issue has disappeared and now you can get NPP in all kinds of mg/ml ratios.

Nandrolone Phenylpropionate (NPP) is dosed at 100 mg/ml and 15 mg/ml with oil.

Nandrolone Phenylpropionate 100mg ml Recipe

Nandrolone Phenylpropionate 100mg/ml @100ml cooking recipe:
Nandrolone Phenylpropionate powder 10gram
2%BA =2ml
20%BB =20ml
Grape seed oil (q.s)

Nandrolone Phenylpropionate 100mg ml Heat Sterilization

The simplest method to clear a steroid solution of microorganisms is to heat sterilize it. The typical way to accomplish this is to place the steroid vial in an oven for 30 minutes (bake at 120°C/250°F). You should leave a needle sticking through the rubber top to equalize the pressure inside the vial, or it may break. Note that a higher temperature and duration are typically used for complete dry heat sterilization, but this is not practical for our purposes due to the potential degradation of vial components, and possibly even the drug components. Still, the recommended 30 minutes at 120°C/250°F should kill most bacteria, and can be regarded as a viable harm reduction strategy.

Some people prefer to use the top of the stove for heat sterilization, and submerge their anabolic steroid vials in a pot of boiling water (100°C/212°F). The vial is kept in the boiling water for approximately 20-30 minutes. While this temperature is sufficient for killing many forms of bacteria and other microorganisms, it is generally not considered the best method of sterilization. A higher temperature should be used. It can also be difficult to control the temperature if the vial rests on the bottom of the pot, which is in direct contact with the burner or heat source. Given these problems, it is preferred to attempt heat sterilization in an oven, as discussed above.

Note that trenbolone appears to break down at fairly low heating temperatures.374 Its degradation increases with temperature and duration. Some degradation may be notable even at 100°C/212°F. As such, trenbolone products should be heat sterilized under slightly different conditions than those recommended above. This typically involves baking the vial in an oven for two hours at 80°C/175°F. Again, an unattached needle should be placed in the rubber stopper to equalize pressure.

Nandrolone Phenylpropionate 100mg ml Syringe Filtration

Another way to attempt sterilization of a steroid solution is to use a filter. A filter is a device that uses a membrane with tiny holes to prevent particles from passing through. The smaller the holes are, the more effective the filter. For this method a disposable syringe filter is used. These are usually found in .45-micron and .22-micron micropour sizes. The .22-micron filter is preferred, as it allows for the removal of almost all forms of bacteria. A .45-micron filter is also acceptable, though more likely to pass certain strains of diminutive bacteria. Syringe filters can be ordered through many mail-order suppliers, which can be located through online search engines without much difficulty.

The procedure for using a syringe filter is fairly simple. First, make sure you have all of the necessary equipment: a syringe, two needles (minimum), a sterile syringe filter, and a new sealed sterile vial. If you are attempting to sterilize a standard 10 ml vial, it may be preferable to use a syringe large enough to draw the full solution. This will reduce the exposure of your product to air. If drawing more than 3 mL at a time, you will want an extra needle to use for equalizing the pressure (you should leave it in the rubber while drawing from the vial). Be careful not to touch critical surfaces (the exposed needle, rubber stopper) while filtering.

Begin by drawing the steroid solution into the syringe. When you are done, remove the needle and attach your newly unwrapped syringe filter. Attach a new needle to the end of the filter, and inject the solution into the new sterile vial. The sterile vial and new needle are very important, as using the original components would only expose the product to bacteria again. Use enough pressure to empty the syringe into the vial. Be careful, as too much pressure can break the bindings or filter. The process is slow, especially with a larger syringe or small .22-micron filter. Provided great care was taken not to contaminate the steroid during the process, the resulting solution should be free of bacteria.

Also, these sterilization methods are applicable to oil-based steroids only. Heat sterilization (as outlined here) tends to cause the rapid evaporation of solvents/antimicrobial agents in water-based steroids. The suspended (instead of dissolved) nature of the particles also makes them likely to jam a syringe filter. Previous testing suggests there is a high prevalence of bacteria in counterfeit and underground water-based steroids.375 Given this, it is generally advised to only use water-based steroids if they have been dispensed through legitimate supply channels.

Nandrolone Phenylpropionate 100mg ml Order Process

1. email or whatsapp us about what you need,quantity and destination.

2. we would answer your email in 12 hours with our best price.

3. If you think the price is workable, we would send you our payment information.

4. After we received your payment ,we would arrange the shipping for you

5. You would receive our package in 7-10 working days.

Nandrolone Phenylpropionate 100mg ml Our Advantage

1. Top Quality in the market, most product have the purity of 98%+ and some beyond 99%

2. Competitive price, we offer speical discount for large amount order.

3. Fast shipping ,we would deliver your product in 7-10 working days.

4. Free Re-shipping, we promise that you will receive your package

5. Security, we will not transfer any of your info to any third party.
Leave a Message Email Us

we will contact you within 24 hours.